Potassium humate is the potassium salt of humic acid obtained from leonardite. Once it dissolves in the soil solution, its humic part takes part in three groups of processes that soil chemists describe for humic substances in general: cation exchange, binding of metal cations (complexation and chelation), and pH buffering. This article explains these processes as principles. It gives no application rates and no effect figures, because the size of any effect depends on the soil, the crop, the product and the conditions.
For the chemistry of the molecule itself (functional groups in detail, molecular size, E4/E6 ratios and FTIR spectra), see Inside Potassium Humate: Functional Groups, Molecular Size and How They Are Measured.
From product to soil solution
When potassium humate dissolves, it separates into potassium ions (K⁺) and negatively charged humate. The potassium content is stated as K₂O on each product’s TDS. The humate is the organic part that interacts with soil particles, soil water and the cations in it.
The reactive part is the humic acid itself: a mixture of organic molecules that carry carboxyl (–COOH) and phenolic (–OH) groups (Stevenson 1994). In soil these groups can release a hydrogen ion (H⁺) and become negatively charged sites. How many sites are charged at a given time depends mainly on soil pH.
Humic acid is not soluble in acid. In acidic soils, or where calcium and magnesium are abundant, part of the dissolved humate can flocculate or become attached to clay and oxide surfaces; in neutral and alkaline soils more of it can stay in solution (Tan 2014). This is one reason the same product can behave differently in different soils.
Cation exchange
Cation exchange capacity (CEC) is the amount of positive charge that a soil or a material can hold in exchangeable form. In most soils, clay minerals and organic matter supply most of the CEC. Humic substances have a high CEC compared with most mineral soil components; per unit mass it is higher than that of clay minerals (Stevenson 1994; Tan 2014).
The charge of humic substances is pH-dependent. As pH rises, first more carboxyl groups and then phenolic groups lose H⁺, so the number of negative sites, and with it the CEC, increases. In acidic soils fewer of these sites are charged.
Cations held on these sites, such as calcium (Ca²⁺), magnesium (Mg²⁺), potassium (K⁺) and ammonium (NH₄⁺), are not held permanently. They exchange with the soil solution: when the concentration of a cation in solution falls, for example through plant uptake, part of the held cations moves back into solution. Cations held in exchangeable form are less exposed to leaching than cations that are free in the soil water.
An applied humic product adds a small amount of organic matter compared with the organic matter already present in most soils. A measurable change in soil CEC should therefore not be assumed; it depends on the amount applied, the soil and the time scale, and it would have to be measured.
Complexation and chelation of metal cations
Besides exchange, humic substances can bind metal cations more strongly by complexation. A carboxyl group, often together with a neighbouring phenolic group, can coordinate a metal ion. When one metal ion is bound by two or more groups of the same molecule, the bond is called chelation (Stevenson 1994; Tipping 2002).
Binding strength differs between metals. Tipping (2002) describes how cation binding by humic substances depends on the metal, on pH, on competition from other cations such as Ca²⁺, Mg²⁺ and Al³⁺, and on the ratio of metal to humic material. In general, ions such as Fe³⁺, Al³⁺ and Cu²⁺ are bound more strongly than Ca²⁺ and Mg²⁺, while K⁺ and Na⁺ are held mainly by exchange.
For micronutrients such as iron, zinc, manganese and copper, complexation with dissolved humic or fulvic material can keep part of the metal in solution under conditions in which it would otherwise precipitate, for example as a hydroxide or phosphate. Complexation with humic material that is attached to the solid phase does the opposite and retains the metal there. Which process dominates depends on the soil, so complexation can make a metal more mobile in one soil and less mobile in another.
The same binding applies to some potentially toxic metals. This topic is covered in Humic Acid in Soil Remediation.
pH buffering: a weak acid–salt pair
The carboxyl and phenolic groups are weak acids. In soil, part of them is present as the acid (R–COOH) and part as the dissociated salt form (R–COO⁻, balanced by K⁺, Ca²⁺ or other cations). Humic acid and its salts form a weak acid–salt pair, which can help buffer the pH: when acid enters the soil, R–COO⁻ takes up H⁺; when a base enters, R–COOH releases H⁺.
Because the different groups dissociate over a wide pH range, humic substances buffer across a range rather than at one pH value (Stevenson 1994). In most mineral soils, the buffering supplied by the soil’s own organic matter, clays and carbonates is usually much larger than that of an applied humic product.
Potassium humate is itself alkaline; see each product’s TDS for its pH. It should not be expected to lower the pH of alkaline soils, and it does not replace liming in acidic soils.
Nitrogen, phosphorus and potassium: principles
Ammonium. Humic acid can adsorb ammonium ions (NH₄⁺) on its exchange sites, which may reduce nitrogen loss by leaching or volatilization. How much depends on soil pH, the nitrogen form and the conditions.
Phosphate. In many soils phosphate is fixed by calcium (in calcareous soils) or by iron and aluminium (in acidic soils). Humic substances can complex part of these cations and can compete with phosphate for some adsorption sites, which may reduce phosphate fixation. This is a principle; whether it matters in a given soil has to be tested.
Potassium. The potassium supplied with potassium humate enters the soil solution as K⁺. It can be held on the exchange sites of humic material and clays and exchanges with the soil solution from there. In sandy soils with a low CEC this may reduce potassium loss by leaching; in clay soils that fix potassium between mineral layers, exchange sites on organic matter may keep part of the potassium in exchangeable form.
Fulvic fraction. The fulvic acid fraction is soluble across the pH range and carries more acidic groups per unit mass than humic acid, so it stays more mobile in the soil solution. Only some potassium humate grades list a fulvic acid value on their TDS.
Water. Potassium humate contains hydrophilic groups; humic substances can hold water, which may help soil moisture retention.
How settled is this picture?
These mechanisms are mostly described with humic and fulvic acids extracted from soil or ore with alkali. Lehmann and Kleber (2015) argued that soil organic matter is better understood as a continuum of progressively decomposed compounds, and that “humus” as a distinct fraction in soil may largely be a product of the extraction. Olk et al. (2019) responded that alkali-extracted humic fractions remain useful in research and in agricultural practice. The principles above should be read with this debate in mind.
What this means in practice
Potassium humate is used for soil application and as a fertilizer raw material. Which grades are suited to fertigation and which only to soil application and granular blending is stated on each product’s TDS; see How Potassium Humate Is Applied. Application rates depend on crop, soil and formulation; ask us for technical guidance and run a small trial first.
Exchange, complexation and buffering all depend on soil pH, texture, existing organic matter and the cations present. A soil test before and after a trial is a more reliable guide than general statements.
FAQ
Does potassium humate raise soil CEC?
Humic substances have a high CEC per unit mass, but an applied product adds little organic matter compared with what most soils already contain. Any change in soil CEC needs to be measured in your own soil; we do not give figures.
Is chelation the same as cation exchange?
No. In cation exchange, a cation is held loosely by charge and can be replaced by other cations from the soil solution. In complexation and chelation, a metal ion is bound more strongly by one or more functional groups. Potassium and sodium are held mainly by exchange; iron, aluminium and copper are bound mainly by complexation.
Will potassium humate lower the pH of an alkaline soil?
No. Potassium humate is alkaline itself (see each product’s TDS for pH). Its acid–salt groups can help buffer pH changes, but it is not an acidifying material.
Where can I read about the molecule itself?
Functional groups, acidity, molecular size and how they are measured are explained in Inside Potassium Humate. Product specifications are on each grade’s TDS; for questions, contact us.
References
- Stevenson, F.J. (1994). Humus Chemistry: Genesis, Composition, Reactions, 2nd ed. Wiley.
- Tan, K.H. (2014). Humic Matter in Soil and the Environment: Principles and Controversies, 2nd ed. CRC Press. doi:10.
1201/ b17037 - Tipping, E. (2002). Cation Binding by Humic Substances. Cambridge University Press. doi:10.
1017/ CBO9780511535598 - Lehmann, J., Kleber, M. (2015). The contentious nature of soil organic matter. Nature 528:60–68. doi:10.
1038/ nature16069 - Olk, D.C., Bloom, P.R., Perdue, E.M., et al. (2019). Environmental and agricultural relevance of humic fractions extracted by alkali from soils and natural waters. Journal of Environmental Quality 48:217–232. doi:10.
2134/ jeq2019. 02. 0041






